Fittings on pp256 torch cooling lines

[haveissues]

Can anybody tell me what fittings are on the end of the torch cooling lines that come with the 256? I'm sure it is some place in this forum but I searched with no luck. Thanks!

[performance]

quick connects that match the cooling units couplers.

[haveissues]

I'm going to be using a cooler I made. Are the quick connects to connect to the torch available anywhere? Can I simply replace them with another fitting with barb and if so, what size barb?

[Zoomie]

I think this is what you're looking for... http://weldingdirect.com/quicmalfitfo.html
They also supply the female connector.

[haveissues]

I assume I am going to find a male on the torch end, correct?

[Zoomie]

Actually mine didn't come with male connectors for the cooler lines on the torch (might have been an anomoly). It did have the Dinse connectors and the gas connectors attached. My understanding is the male connectors and hose clamps come packaged with the W300 cooler.

Z

[haveissues]

Ah, I see. Thanks for the reply. I'm just trying to get everything together so I can test out the pp256 when it shows up.

[Zoomie]

Haveissues,
Off topic but you should go to the greenbucks thread and enter the contest for Everlast "greenbucks". Get an Avatar, post a sig and make 60 posts before the end of April. Hey free is good and a cooler would go great with that 256!

Z