How about a post of settings you use for various things, in an intelligible format such as;

Plasma or TIG
Metal type
Flat or inside corner or outside corner or curve
thickness
argon flow or alternate gas
pulse settings ac or dc or reverse
Pre flow post flow
upslope down slope
2t/4t

Some sort of setting for each dial


Some person better at this than me can make a quick format to use so we can easily get a good crack at saya s common as...an aluminum butt-weld. Or as obscure as a Magnesium pipe weld. There is lots of information to glean from the posts already here, but a 'favorite settings thread would be very very nice.

The settings can be used as a starting point as your mileage may vary, but it IS a starting point, and all in one thread.