Project # 2 Welding table

[yotarover]

Attachment 2181

dont remember the specs on this thing very well. but i made it from 4x4" rec tubing for the legs they were over 6' long. top is a 1/8" thick steel sheet 5'x6'L . needed something solid to weld on and this thing worked great. welds were solid and clean was strong enough to have hold up completely asseimbled toyota 22re engines (i strapped them down to keep them from falling). each end of the tubes were open to slide in pipe ,rods,etc or sliding in my drill press or chop saw when i need a good solid base. total cost was around 200 for all the material(not the welding rods )