Hey all, here are a few pics of an exhaust I'm working on for a friend of mine.
3" 304 (.055 wall) stainless mandrel bends that he got from jegs.com
3/8" stainless flanges
6" stainless flexpipe
Used mild steel exhaust cutout
Welding it up with my powerpro 205
2% thoriated 3/32 tungsten ground to a point
~65 amps to weld the pipe to the flange, and flex pipe, ~ 40-42 amps for butt welding the pipes
308l 1/16" filler for everything except the cutout for which I'll use 309l.
On to the pics!!!

The flange welded up


This is about 3/4 of it, ran out of argon, so I'll get a refill tomorrow, and weld on the cutout and another flange to finish it up.
I'll post more pics when I finish it!



Got a little crazy on the flex...lol still, not increibly bad for t total noob, it's my first real project