I need some assistance from tech support. I’m looking into getting arc voltage torch height controller for my CNC for use with the PP50 I purchased at the beginning 2010. I’m finally going to break down and buy one. It seems like I’m always hovering over my CNC staring at this thing cut making sure the nozzle is not scraping as it cuts warped plate, and I hope to get more consistent cuts using one.

Here is the website about the height controller I plan to get http://www.candcnc.com/LCTHC.html

Here is my question. Does the PP50 have an “Arc Ok” signal output, and is it accessible to me? If it is accessible to me, will it void the warranty if I hook into it? I need to know because if it does not have one, I’ll need to purchase an additional option for $18.00.

Thanks again,
Chris