Well, I stopped by your booth and chatted you guys up for a while. You also gave me a hard time for being a lurker, so I figured this would be a nice place to say hi! Nice to met you guy, and hope you had fun at the rest of the show.
Mark
Well, I stopped by your booth and chatted you guys up for a while. You also gave me a hard time for being a lurker, so I figured this would be a nice place to say hi! Nice to met you guy, and hope you had fun at the rest of the show.
Mark
It's about time for Fabtech in Chicago- no rest for weary trade show exhibitors!
DaveO
Oxweld oxy acet gear
IMIG 200
PowerTIG 210 EXT... Amazing!
HAHA I know what those are! Catalytic converters lol
I Love Plasma and rolleye's at the costly addiction of MAPPgasoron's.
http://brothers2woodworking.webstarts.com/
Everlast Plasma cutter Power Plasma 50
Everlast PowerArc 200 ~ Happily Married To That gutsy babe, git'er dun.
Wishlist: Free consumables, Small TIG maybeAlex, when you have overstock give me ring!
I would love to attend SEMA! Not so sure I would want to work SEMA!
Lincoln Eagle Engine Drive
Everlast MTS 250
Everlast Power Tig 225lx
HTP Mig 2400
Everlast Power Plasma 60C --> Just need to finish my CNC Plasma Table!
Miller Spectrum 375 Extreme Plasma cutter
Victor cutting torch
HF 20 Ton Shop Press
HF 4x6 Band Saw
HF Air Compressor
Northern Tool Drill Press
www.murphywelding.com
____
Ray
Everlast Sales and Support Team.
support@everlastalaska.com
www.everlastalaska.com
877-755-9353 X207
When younger I did a lot of shows. I can tell you they are bad until you get used to doing them, if you have a good family/home life.
Now the chance to run around (at the right show) is a lot of fun if enough time allowed.
But the managing the booth part in general is work, and nothing worse than times with no traffic..
Also, Mike should have stated, the lurking was here on the forum (not signed up, just reading), not lurking at the booth. Ray told me the story. Sounded a little scary when I read Mike's post![]()
Mike R.
Email: admineverlast@everlastwelders.com
www.everlastgenerators.com
www.everlastwelders.com
877-755-9353 x203
M-F 12 - 7PM PST
FYI: PP50, PP80, IMIG-200, IMIG-250P, 210EXT and 255EXT.