Need a little help with my new machine

[Ray]

Still not clear on what was incorrect? The manual? Or themarkings on the welder.

Does the manual say to connect to the positive port.

I was under the understanding the connectors were markedTorch and workpiece.

I’d like to know so I can direct other correctly, I haven’tseen one of the special units yet.

[dennis]

The manual was wrong and the face plate was right. It works now. A little bit shy of the specs for power. I'll need to adapt a torch that fits me better. I just ran a few sticks of 1/16" 6013 and it did good. I cut all the parts for my new welding cart and it done real good.

[RiverRunner]

Hi i have the same machine mine works fine all but the digital display, it seems to be stuck on 1 the amperage will still adjust fine but the display only reads one no matter where the knob is turned. I have unplugged, checked fuse, changed function an nothing fixed problem! any help would be greatly appreciated!

[dennis]

you need to talk to customer service. They did me right.