Share
Results 1 to 17 of 17

Thread: pp256 spark in front of panel

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 12-19-2011, 01:59 PM #1
    charger891's Avatar
    charger891
    charger891 is offline Member
    Join Date
    Nov 2011
    Location
    manitoba
    Posts
    162

    Default pp256 spark in front of panel

    finally had a bit of time this weekend to do some welding, only the second time i get to use this machine, set up the tig, open up the regulator, just going to purge my line, regulator wasen`t working, was just going to tap on like i dod last time and noticed a nice bright spark coming from the tig switch plug in to a bolt on the side panel, so i imediately checked the connection and removed and re-installed it and as soon as i hit the trigger on the torch i get this spark, WTF!!!

    http://i925.photobucket.com/albums/a...1/IMG_0149.jpg
    Last edited by charger891; 12-19-2011 at 02:03 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Spark Container
    By Gerry in forum Everlast Plasma Cutters (PAC)
    Replies: 5
    Last Post: 12-10-2012, 07:50 PM
  2. Spark Gap Contacts
    By Ron66 in forum TIG Welding (GTAW/GTAW-P)
    Replies: 28
    Last Post: 10-03-2012, 01:50 AM
  3. Front panel issue...
    By millermatic in forum Everlast Plasma Cutters (PAC)
    Replies: 2
    Last Post: 08-28-2012, 04:07 AM
  4. Got a spark, but no cut, not an Everlast unit though.
    By CSR in forum Everlast Plasma Cutters (PAC)
    Replies: 24
    Last Post: 09-08-2010, 05:14 PM
  5. The Plasma air pressure low sensor on the front panel
    By everlastsupport in forum Technical Bulletins and Tips
    Replies: 1
    Last Post: 12-22-2009, 12:00 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules