Member
200DX pedal issue - erratic arc
I have an issue where the arc is somewhat erratic when i use the foot pedal on my 200DX. Can anyone advise if these readings from the pot on my foot pedal are correct:
Brown wire to red: 2250 - 0
Brown wire to green: 2400-328
here are some photos of the inside and outside of the pedal:
Thanks
Some of the crap I use to keep busy:
Everlast 200DX
Millermatic 211 Mig
Hypertherm Powermax 30 plasma cutter
Lincoln Weld-Pak 100
Century Stick welder
Oxy set-up with Henrob 2000 torch
Logan 200 lathe (60 years old)
Jet band saw
About 6 Harbor Freight grinders with different discs/wheels/brushes
Member
yes, the pot in the middle photo is the one i tested.
Some of the crap I use to keep busy:
Everlast 200DX
Millermatic 211 Mig
Hypertherm Powermax 30 plasma cutter
Lincoln Weld-Pak 100
Century Stick welder
Oxy set-up with Henrob 2000 torch
Logan 200 lathe (60 years old)
Jet band saw
About 6 Harbor Freight grinders with different discs/wheels/brushes
Member
so then those are the right numbers, and that is the correct pedal for the 200DX?
Some of the crap I use to keep busy:
Everlast 200DX
Millermatic 211 Mig
Hypertherm Powermax 30 plasma cutter
Lincoln Weld-Pak 100
Century Stick welder
Oxy set-up with Henrob 2000 torch
Logan 200 lathe (60 years old)
Jet band saw
About 6 Harbor Freight grinders with different discs/wheels/brushes
Everlast Sales and Support Team
that is the correct pedal for the DX series.
____
Ray
Everlast Sales and Support Team.
support@everlastalaska.com
www.everlastalaska.com
877-755-9353 X207
Member
thanks Ray
Some of the crap I use to keep busy:
Everlast 200DX
Millermatic 211 Mig
Hypertherm Powermax 30 plasma cutter
Lincoln Weld-Pak 100
Century Stick welder
Oxy set-up with Henrob 2000 torch
Logan 200 lathe (60 years old)
Jet band saw
About 6 Harbor Freight grinders with different discs/wheels/brushes
Posting Permissions
Reply With Quote