Trifamet / Binzel Mig torch Question

[SeanMurphy265]

Can I add a 20' mig torch to my Imig 200?

[DaveO]

What about the ability of the wirefeed to push wire that far, around potential bends / curves etc? Is that a question mark?

[zoama]

Can I add a 20' mig torch to my Imig 200?

If it has a euro connector this one will work... http://www.everlastgenerators.com/fo...-my-I-MIG-250p I like it much much better than the OEM. It's a little pricey but worth it.

[performance]

Sean,
It shouldn't be an issue, but keep in mind, bends will foul up even a short one on feeding at times. The longer it is, the straighter you will want it to run.

[zoama]

I find it easier to work with a longer cable. There's always plenty of slack so the cable doesn't get pulled into tight bends.