Hi -
I am using my PP50 for the second time and there is no arc; when trigger is pulled there is no air flow - when I release the trigger air flows normally. Fuse is good, settings look correct. Thoughts on what the problem may be?
Thanks
-Nick
Hi -
I am using my PP50 for the second time and there is no arc; when trigger is pulled there is no air flow - when I release the trigger air flows normally. Fuse is good, settings look correct. Thoughts on what the problem may be?
Thanks
-Nick
Check to make sure your swirl ring is inside, and you consumables are tight.
What does you meter show when you pull the trigger?
Mark
performance@everlastwelders.com
www.everlastgenerators.com
www.everlastwelders.com
877-755-9353 x204
M-F 9am - 5pm EST
That isn't a low pressure light. That is a correct pressure light. It is on while pressure meets minimum safe standards. It doesn't mean it will cut well though...but just tells you that the pressure meets the minimum standard to keep the torch from burning up. Recommended pressure is between 55-70 psi.
Mark
performance@everlastwelders.com
www.everlastgenerators.com
www.everlastwelders.com
877-755-9353 x204
M-F 9am - 5pm EST