Who has a plasma table?

[SeanMurphy265]

I have an idea for something I would like to get some 3/8" - thick plates cut out, with some holes. I'm needing 2 plates, but I'm in no hurry and can wait until you have a job on the table with room.

[todmorg]

I have an idea for something I would like to get some 3/8" - thick plates cut out, with some holes. I'm needing 2 plates, but I'm in no hurry and can wait until you have a job on the table with room.

I do, how big are the parts? where you located ( shipping can be a killer )?

[SeanMurphy265]

38821
I'm not wanting something huge. I figure 25lbs at the most. 3/8" thick 4"wide no more than 24" long.

[cpierce18]

I have a 52” x 84” CNC plasma table.

I would be glad to work you up a quote. Email me at chris.pierce@pierceworks.net
You could check out some work at www.pierceworks.net (Sorry, website is still slowly under construction)

Please email me and include the following for each part you need.
1. A sketch if possible (or a describe the part)
2. Thickness
3. Material type (Carbon Steel, Stainless or aluminum)
4. Any tolerance requirements you need
5. Rough time frame of when you would need it
6. Ship-to location.

[SeanMurphy265]

I've got an inside track coupon for the Harbor Freight tube roller that I'm going to pick up this weekend. I have an idea that I want to try. I will get all the measurements this weekend.

[cpierce18]

For those of you who have a CNC plasma cutting table with the PP-50 cutter, here are some specs that gave me great cutting results.

A customer came to me with a job cutting (16) ¼” thick brackets, and possibly more depending on the quality of the work.

Apparently the first set of brackets came out great because he just came back for another (32) brackets.

Here are the specs. I used for cutting.

PP-50 with the hand torch.
Material- ¼” A-36 Carbon Steel
Air Pressure – 65 psi
Cutting Amps - 45
Pierce Height - 0.25”
Pierce Delay – 0.25 seconds
THC Cut voltage – 106 (around 0.7” cut height)
Hole Cutting Feed Rate – 25 IPM
Perimeter Cutting Feed Rate – 40 IPM

Edge quality turned out great and the 13/16” diameter holes for ¾” Bolts came out with a very minimal bevel & dross.

[sportbike]

I have a 52” x 84” CNC plasma table.

I would be glad to work you up a quote. Email me at chris.pierce@pierceworks.net
You could check out some work at www.pierceworks.net (Sorry, website is still slowly under construction)

Please email me and include the following for each part you need.
1. A sketch if possible (or a describe the part)
2. Thickness
3. Material type (Carbon Steel, Stainless or aluminum)
4. Any tolerance requirements you need
5. Rough time frame of when you would need it
6. Ship-to location.

Chris,
Are you in Elizabeth PA as in near Pittsburgh on 51? I live near Johnstown, but I often use a shop in Uniontown for tuning and building my bikes. My buddy who races with me lives near Homestead.

John

[cpierce18]

John,

You are correct. I live south of Pittsburgh near Elizabeth & Rt. 51. I make it down to Homested every now and than and am pretty sure I've passed thru Johnstown on my way to State College.

What kind of bikes you build?

[cpierce18]

Here are a few pictures of the brackets.