Member
Welding practice on Friday
Well, here I have an uphill weld...Four passes of 7018 at 90 amps on 1/8" steel.
Here I have just one pass of FCAW.
And here I have 7 passes, yes seven passes, of 7018 at 120 amps. The weld is about 1-3/16" wide.
This was all performed with my Everlast IMIG 200.
Benjamin
Owner of IMIG 200 and half owner of Power Plasma 50
https://www.facebook.com/BenjaminRootPhotography
Member
Mighty fine Benjamin. I need to practice a lot.
Thurmond
Miller Bobcat 3 Phase,
Miller Suitcase X-Treme 12VS wire feeder for the Bobcat with M-25 300A .045" gun / Bernard 400A 5/64" wire mig gun .
26 series gas cooled TIG torch, setup for quick connect to Bobcat.
17 series gas cooled Tig Torch for Low Amp Solar Tig (Direct Solar Panel Powered Tig welding)
Hobart Handler 187 Mig / Fluxcore
EVERLAST PowerUltra 205P
EVERLAST PowerTig 250 EXT 2013 Model
Member
Thank you! I am in the process of getting 75/25 Ar/Co2 so that should help me out some with better wire welds.Originally Posted by Tritium
Benjamin
Owner of IMIG 200 and half owner of Power Plasma 50
https://www.facebook.com/BenjaminRootPhotography
Posting Permissions
Reply With Quote