K frame stand
Well here is project 1 for spring contest. I had some scrap 1 1/2 x 1 1/2 X 1/8 square tube, 1 1/2 angle and 2 x 1/8 flat plate. The tube was pretty nasty so I cleaned it as well as I could with a flap wheel but it still tough to tig weld and a little ugly. So heres some pics of a stand I built to hold a Mopar kframe so it will be easier to put suspension and and mount engine and tranny and install by lowering the car on it like they did at factory. I welded it in pieces and bolted together so it could be taken apart and stored. Again I am not a fabricator or a welder so it is crude but hope it will work as planed . It is still a work in progess.
Reply With Quote