Will the PowerPlasma 60C cause hi-frequency interference on a CNC table?

[zoama]

Sounds good. Believe me, if it works great I'll be posting in the thread on plasmaspider to say so. On the Everlast it says it is a HF machine, you say it does not produce interference, I am just going to assume it is a different style HF type that has been designed differently to not cause problems or something.

I don't see HF listed in the description... Source: http://www.everlastgenerators.com/Po...0C-366-pd.html

Features & Benefits
- High Voltage/Inductor Start is excellent choice for CNC operation with the fastest pierce times. This is different than HF starting as the frequency is lower, reducing the risk of interference associated with typical HF/HV starts.