Looking to make a mounting bracket with beveled screw holes, as in this photo.
Is there a specific bit for this? I'm familiar with countersink bits for woodworking, but not aware of the same bit to use on steel. Anybody seen this?
Senior Member
Is there a bit to make a beveled hole?
Looking to make a mounting bracket with beveled screw holes, as in this photo.
Is there a specific bit for this? I'm familiar with countersink bits for woodworking, but not aware of the same bit to use on steel. Anybody seen this?
DaveO
Oxweld oxy acet gear
IMIG 200
PowerTIG 210 EXT... Amazing!
Posting Permissions
Reply With Quote