A friend that races in a local series was wanting some numbers for the side of his Jeep that wouldn't always be visible, no matter how muddy the course gets. Here was the solution:
Member
Project #3 from Tacoma747, Category: Metal Repair, Custom cut numbers on race vehicle
A friend that races in a local series was wanting some numbers for the side of his Jeep that wouldn't always be visible, no matter how muddy the course gets. Here was the solution:
http://www.facebook.com/CBRMetalworks
'96 Tacoma V6 on 37's, full custom, built for racin!
Yamaha Rhino w/ 800 Rotax built for racin!
Miller 251 MIG
Everlast Powerplasma 60C with CNC plasma table
Looking for sponsors for KOH 2013 race!
Racin' Tacoma Build Thread
Member
In progress:
http://www.facebook.com/CBRMetalworks
'96 Tacoma V6 on 37's, full custom, built for racin!
Yamaha Rhino w/ 800 Rotax built for racin!
Miller 251 MIG
Everlast Powerplasma 60C with CNC plasma table
Looking for sponsors for KOH 2013 race!
Racin' Tacoma Build Thread
Member
And installed, I will probably make one for the other side to match, although the officials are always on the drivers side, at least so far...
http://www.facebook.com/CBRMetalworks
'96 Tacoma V6 on 37's, full custom, built for racin!
Yamaha Rhino w/ 800 Rotax built for racin!
Miller 251 MIG
Everlast Powerplasma 60C with CNC plasma table
Looking for sponsors for KOH 2013 race!
Racin' Tacoma Build Thread
Posting Permissions
Reply With Quote