Well, now that I have a $750 gift certificate from teh last contest, I think I am going to look a bit more seriously at a plasma cutter. I would like to get a 210EXT to replace teh 200DX, but quite frankly, i have no issues with the 200DX so there is no real need to change.


In looking at the specs, the current requirements of the 60C don't really make sense. 27A inrush and 21A running at 240V. I see that the voltage now shows single phase rather than 3 phase. Are these current numbers correct for 240VAC operation?

The 50 shows 37A inrush, 29A running @ 240V.

If I get one, it will inevitably turn into the cutter for a CNC system. That said, I typically only work in the 1/4" and under range. (usually only .090-.125 for aluminum).



Additionally, is there a hand torch available for the 60C as well?




John