New PP50 owner.

[Nateh]

I placed an order for the power plasma 50 on New Years Eve. I talked to Alex a few time and placed my order. This PP50 will go into my garage where I will be using it to cut out brackets, and tube for building bumpers, rock slinder and cages for offroad rigs. I am building a 4runner truggy right now. I have been using a TD plasma at so.

Well I got my plasma a few days ago and hooked it up. Everything is working great. I went out and started cutting brackets so I can mount my rear axle in. Its so nice to have a plasma.

Now I am thinking of getting a mig welder from Everlast. What type should I be looking at for welding up to 1/2"?

[performance]

The Power I-MIG 250 is the best choice and for about $1400.00, it is a super deal. IT has 250 amps of pulse MIG ability, with a 4, yes that's right a 4 drive roller feeder. It also can carry a full size roll of wire, and burn up to .045 wire depending on the drive roll arrangement.

Mike our tech support guy has bought one and is by his last words to me, not getting to use it much, because his son loves it.

Perhaps Mike can give a little clearer picture on this unit.

[WAYNESWORLD]

How about a few pictures of the unit too?
Wayne