What Torch Head?

[zoama]

My Supercut 50P should be here Wednesday. I was planing on ordering some consumables for it but was wondering what I should be getting. In other words what parts wear out the fastest. I don't want to order a ton of ceramic shield cups if they tend to last a long time. Any advice?

I replace the tip and electrode in sets. The cup lasts forever unles you break it. Wherever you order from be sure to get small tips. you can request .9 or 1mm, I would go with .9 here's an example http://www.ebay.com/itm/90pcs-SG-55-...item19caca6e96.

[cbmkr]

That's what i was looking for , the one i found online was the old style manual same as came in the box, Its downloaded and saved in my system. i am going to try and find some drag tips this week.

Thanks Mark

[zoama]

That's what i was looking for , the one i found online was the old style manual same as came in the box, Its downloaded and saved in my system. i am going to try and find some drag tips this week.

Thanks Mark

You can drag the ones with the notches in the face of the tip (most common) up to 30 amp. I use a square as a guide... you just have to offset it a little from your line.

[ShaneJackson]

As far as the ceramic cups, should I go with these so I can use the spacer guides:
http://www.river-weld.com/10pcs-5060...064_p7429.html
or these:
http://www.river-weld.com/10pcs-shie...004_p7431.html

I am guessing the only difference is the groove for the spacer?

[zoama]

As far as the ceramic cups, should I go with these so I can use the spacer guides:
http://www.river-weld.com/10pcs-5060...064_p7429.html
or these:
http://www.river-weld.com/10pcs-shie...004_p7431.html

I am guessing the only difference is the groove for the spacer?

The first, but unless you break it they last forever.