Project 1 from Undercut. Category: Welding Cart

[undercut]

I was in dire need of a welding cart. I can't weld where I store my stuff so I need to move everything to my welding spot and then move everything back when I'm done.

I used steel angle, steel square tubing and some steel flat bar for this project. All pieces welded with stick (still need to acquire an argon tank).

As you can probably guess, space for me is a premium so I'm making the top of the cart roughly 30" off of the ground so that it will perform double duty as a work bench.



I needed to perform some coping cuts on the angle to get them fit flush against each other. Never worked with angle before so that was an unfortunate discovery.

I'll be putting my welder on the bottom and putting in a shelf above it to store all of my welding accessories. Tank goes on the back shelf and I'll have electrodes on either side of it. A work surface will go on top.