Plasma Cutting Settings Super 200P

[CapnMilo]

Want to confirm the settings when using the plasma cutting feature on the Super 200P

All Dials set to Zero or Min. except for Current Control
AC/DC set to DC
2T/4T set to 2T
Pulse/DC switch to DC
Mode Switch down (Plasma Cutting)
Air At 65 - 70lbs

I am assuming the Current Control dial is the only dial used to select amperage for plasma cutting

[everlast_support]

That is correct.

Also, for thinner metals, sometimes under 60PSI will yield a thinner cut. On aluminum make sure you angle the torch say 45 degrees to avoid spatter in the tip.

[CapnMilo]

When does the digital readout display the amperage?

[everlast_support]

When you set it with the AMPs knob. It is really just to assist in setting the amps.