Plasma cutting tips for my PP256

[jonathan5685]

Anyone have any advice for better tips that make it easier to see where the actual cut will be? I have the A-81 torch. Maybe some drag tips ? Tell me what you use and what works for you

[zoama]

Anyone have any advice for better tips that make it easier to see where the actual cut will be? I have the A-81 torch. Maybe some drag tips ? Tell me what you use and what works for you

Get a roller guide or drag tips. For straight cuts I use an aluminum straight edge and drag the roller or tip against it... just allow for the distance between the straight edge and where the actual cut will be. Once you have the measurement you'll use that same offset every time. For short cuts and square tubing I use a speed square.

[performance]

I use PRACTICE. Nothing substitutes for it.

[zoama]

I use PRACTICE. Nothing substitutes for it.

You freehand everything ?

[performance]

Pretty much, unless it is a long cut that I need precisely. But a lot of it transfers from my torch skills...
http://www.youtube.com/watch?v=ZcNqc2IzNrk&feature=plcp

[zoama]

Pretty much, unless it is a long cut that I need precisely. But a lot of it transfers from my torch skills...
http://www.youtube.com/watch?v=ZcNqc2IzNrk&feature=plcp

I haven't used an O/A torch in 23 years but I used one every day back then, cutting I beams and guardrail. For me plasma is faster and leaves a cleaner edge... I gotta use a straight edge or my cuts look like fido's butt.