It's too bad that table doesn't fold up for easier storage. I like how you used every last scrap of metal though! Do you MIG weld more often than TIG? It might be a good idea to get a piece of (dirt cheap) 24 gauge galvanized sheet metal bent up at a local HVAC shop to cover your nice table top when MIG welding. I messed up a nice table top at work years ago while MIG welding (dingle berries EVERYWHERE!), and from that point forward I had to use the DA to smooth out the top surface after MIG welding. Of course that always promoted rust during the cold weather as the table was outside under an awning. It's impossible to stop surface rust when leaving a welding table outside, even when it's covered up and under an awning!