Rotenbach Super 200p

[Gazampher]

Hi Woody,

I was wondering if you made any progress with your broken Super-200p. From reading your posts I seem to have almost the same problem except I believe I may have made mine worse by not putting the unit back together correctly. Do you have any pictures to hand to help me put all the connectors back into the correct sockets please.
It is mainly the wires from the fron control board and the one mounting behind it.

Thanks

[zoama]

Hi Woody,

I was wondering if you made any progress with your broken Super-200p. From reading your posts I seem to have almost the same problem except I believe I may have made mine worse by not putting the unit back together correctly. Do you have any pictures to hand to help me put all the connectors back into the correct sockets please.
It is mainly the wires from the fron control board and the one mounting behind it.

Thanks

Be aware that the machine in this thread is not an Everlast and not the same build.

[Gazampher]

Mine too is not an everlast machine, it has LTS on the side which as far as I can work out is a UK importer of these machines. I have not had much luck with them as I was not the original buyer and it was purchased back in 2009. From the pictures mine appears to have the same electronics inside but I cannot work out exactly what connections go where.

I think with a bit of time and effort using my experiance in electronics I could reverse engineer the electronics and create some schematics for each of the boards used in the unit. I already have done the main power control PCB located at the bottom, the others will take some more time as they are a bit more complicated.

If anyone can help with the internal wiring I would be very greatful.

Cheers.