New PowerTig 250 EX manual

[performance]

The new manual for the 250 EX is up. Several have asked to see it when its up...so here it is. Again, it isn't a welding primer, and that isn't the goal.
http://www.everlastgenerators.com/do...werTIG-NEW.pdf

[Rambozo]

The new manual for the 250 EX is up. Several have asked to see it when its up...so here it is. Again, it isn't a welding primer, and that isn't the goal.
http://www.everlastgenerators.com/do...werTIG-NEW.pdf

Looks like an outstanding manual. Now if you could only get every new owner to read it.

[Kempy]

The new manual for the 250 EX is up. Several have asked to see it when its up...so here it is. Again, it isn't a welding primer, and that isn't the goal.
http://www.everlastgenerators.com/do...werTIG-NEW.pdf

I have gone over it quickly and page 19 is a little mixed up the numbers don't all match up the number 6 is not in the list and there are two number 5’s sorry for the bad news. The information is right just he numbers need to be changed. The 2013 book is very nice and give a lot of good information on the unit. Just trying to help make thing better.

[performance]

No problem. If that is the worst error...
Already changed it. Any more things you see post it asap so we can get it right one final time.

[Kempy]

I am impressed it is a very nice manual, answering my question that have come up on the forum the pictures are clear and detailed very well.
Good work EVERLAST

[Oleg]

I am impressed it is a very nice manual, answering my question that have come up on the forum the pictures are clear and detailed very well.
Good work EVERLAST

Kempy.. thank you but it was all done by MARK ..


he did amazing job !

[Kempy]

Kempy.. thank you but it was all done by MARK ..


he did amazing job !

Should I say good work Mark at Everlast, or Good job people at Everlast and that would get everybody at Everlast. GOOD work anyway.

[Kempy]

Mark
The front page and page 9 of the 2013-250EX the picture does not have the Surge Amps knob. Looking in the manual on page 12 and 13 the knob is missing also but it is on page 15. Just trying to help. Hope I am not too picky.

[performance]

The generic line drawing picture isn't there for accuracy or representation of the control panel. As the spec says, it isn't available to late 2013. The point of page 13 and 15 is connections...not panel detail.

[cbmkr]

Very nice job on the manual, Very Clean and straight forward easy to understand and not to complicated to confuse the end user.
Looks Good Mark