Hey guys, this is my first post here, obviously. I've got a question for ya'll. Just got a new Supercut 50p plasma a month or so ago and yesterday was only the second time I used it. I did some cutting on a 1/4" piece of steel, maybe 10-15 mins of cutting. Then it suddenly stopped working and I noticed the warning light came on. It took me a minute, but I finally saw in the water trap (the one that came with it), that it had about 1/2" water in it. Is this why the warning light came on? I've never used a plasma cutter before this one, so I'm very noobish on these issues. If the water in the trap was the reason the light came on, then how do I take care of this problem? My compressor was empty when I plugged it in before I started cutting. It got up to between 120-150 psi then I attached it to the plasma cutter. What do I need to do today to be able to use it? Thanks for your help.