Rambozo 
2013 Summer Project #1 Micro Cart
Well the rules didn't say anything about project posting titles, but I figure I'll be able to find things easier at the end if I do it like this.
I've been thinking about a different sort of little welding cart for a while. I wanted something small that could go over rough terrain or be pulled up stairs. So I went for a two wheeled design, instead of the typical four wheeled. For compact use I have a 55 cuft. bottle, but I can go larger as well.
I sketched out the basic plan and used ¾†EMT for all the tubes and a couple of 11ga. plates. I did sand back the galvanizing near the weld areas with a flap disc, and fish-mouthed everything for a good fit-up. To stay authentic, I did all the welding with the 140ST using 3/32†2% lanthanated tungsten and ER70S2 filler, with about 12 CFH argon.
I think I have too many pictures, for a single post. So I'll split it here.
