Hi All,

Just as the title implies I need some help to choose a compressor for my new PowerPro 256SS.
I have the S71 or S75 torch and the biggest job I need to do is to cut 3 inch diameter circles from 1/8 inch plate Aluminum.

My issue is not cost of the compressor, its the weight and noise.
I have a RV and I need to keep the weight under 80 pounds or so.
It also needs to be quiet as I will be working at RV parks/Marinas and dont want to make too much noise.
It also needs to be electric.

I was looking at the California Air Tools 10 Gallon 2HP model it puts out about 3.50 CFM at 90 psi.
This is a side job, I just need to know if this will be enough air to cut one circle, take a break, cut another circle, take a break.... and so on for a max of ten circle plates.

Thanks,
Mike.