Share
Results 1 to 2 of 2

Thread: tig welding a fillet weld help

  1. 01-01-2014, 02:39 AM #1
    steve1989
    steve1989 is offline New Member
    Join Date
    Jul 2013
    Posts
    27

    Default tig welding a fillet weld help

    can some one give good directions on doing a fillet weld on steel. torh angles?
    Reply With Quote Reply With Quote
  2. 01-01-2014, 12:36 PM #2
    everlastsupport's Avatar
    everlastsupport
    everlastsupport is offline Everlast Support Team
    Join Date
    Jul 2009
    Location
    Florida
    Posts
    3,370

    Default

    I try to stay vertical, not more that 10-15 degrees from there. Also, I like a short stick out normally 1/4" or less. Push the pool.
    Mike R.
    Email: admineverlast@everlastwelders.com
    www.everlastgenerators.com
    www.everlastwelders.com
    877-755-9353 x203
    M-F 12 - 7PM PST
    FYI: PP50, PP80, IMIG-200, IMIG-250P, 210EXT and 255EXT.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. How to weld TALL weld beads on 1.6mm thick Aluminum Tube?
    By Welderooni in forum TIG Welding (GTAW/GTAW-P)
    Replies: 4
    Last Post: 10-08-2013, 02:49 PM
  2. PowerTig 200DX settings for aluminum 1/8" corner join and inside fillet???
    By PeterA in forum TIG Welding (GTAW/GTAW-P)
    Replies: 4
    Last Post: 11-09-2012, 02:15 AM
  3. First Attempt at an Aluminum Fillet Weld
    By blasphemy000 in forum TIG Welding (GTAW/GTAW-P)
    Replies: 6
    Last Post: 08-11-2012, 10:30 PM
  4. Some weld pictures I took of welding
    By MigPlazArc in forum Hobyist Projects
    Replies: 15
    Last Post: 07-05-2012, 03:34 PM
  5. Penetration of weld and weld build up?
    By CGCINC in forum General Welding Questions
    Replies: 4
    Last Post: 07-03-2012, 08:06 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules