Hi all
I just received my new 60c plasma cutter and I am having problems with it stopping my system when it goes to plasma on (Interference I guess). It will make a few of the cuts then it stops the program and always on the plasma start command. Sometimes it will cut the whole part with out a problem. I have had my lighting cnc table for about a year using a router with out any issues. I have the plasma cutter grounded and the table grounded I even ran a ground to the control box but still having the same problem.
I moved the plasma cutter to the right and the computer system to the left, I remounted the control box to my computer cart so its as far away as I can get things. I can only get each about 5 feet from the table. When it stops if occasionally locks up the mouse and if has blown the small control fuse on the front of the plasma cutter.

I purchased it just because I thought it did not have these types of issues. I am really impressed with the quality of the 60c and do not want to send it back.

Any help would be appreciated!!!!!
Bill..........