Disassembly of Power Itig 200

[Klr49adv]

I was wondering if there is a manual for the disassembly of this machine. Need to check out the high frequency gap and hoping to make it a little easer on myself with some instructions. Thanks.

[zoama]

I was wondering if there is a manual for the disassembly of this machine. Need to check out the high frequency gap and hoping to make it a little easer on myself with some instructions. Thanks.

Remove the screws that hold the rear panel on, remove the rear panel and carry handle, remove the screws along the bottom of each side of the cover and remove the cover.

When you put it back together, just barely tighten the side screws since they're easy to strip.

[performance]

+1 on Zoama's comment. I have gone out to fastenal and replaced the side screws with harder black oxide socket head cap screws before. Quite nice looking results if I don't mind saying so myself.