New PowerMTS 251Si videos posted by Kevin and ChuckE

[performance]

Some of you have been wanting more information about the PowerMTS 251Si. Here are a couple of review videos from Kevin Caron and from Lanse (ChuckE2009)

https://www.youtube.com/watch?v=LPPgiwYZriQ

https://www.youtube.com/watch?v=agvUUpADAUM

[Kevin Caron]

Love this machine!!

Now if you could just get us A/C for the Tig!!!

[Rambozo]

On the flip side, will some of this technology make it into the standard MIG machines for those of us that don't want everything crammed into one box?

[Kevin Caron]

I think that is happening very soon..... Or so the little bird told me...

[performance]

It's already there. The 200 and 205 already are digitally controlled.

[performance]

It has already happened the i-MIG 200 and 205 are already digitally controlled.

[TheGary]

There are some nice improvements on the 251. I like the control panel setup better than my mts250s. Although I have no real problem with my controls. One thing I really like that I wish my mts had is more voltage ,30 volts is good. The mts should of had that much voltage available. On heavy plate I run my MM200 at 30 volts a lot. The MTS I have to take more time because I do not have the voltage with only 26.5v available. The HF is a good improvement also but the lift arc is not a deal killer. I would like the pulse feature for my spool gun on thin aluminum. It also is nice for vertical up short circuit welds. I can live without it but it does make for nice looking vertical up mig welds.