2016 PowerPlasma CNC Port

[knock10090]

Hello,

Getting ready for a PowerPlasma purchase and I have a question about the new 2016 models that are coming out.

Has the CNC port pinout problem for THC control been addressed in the new 2016 models? Specifically, if utilizing a Proma THC unit that requires the full voltage reading to operate. In all of the research i've done, most of the posts dating back a few years say that the Proma's are only reading about 1/2 the voltage that it should be.

Has there been a solution to this??

Thanks
Matthew Knock
Trooper K Fabrication

[performance]

It doesn't read raw voltage as far as I know. It's divided. No changes were scheduled to be made.

[knock10090]

As far as THC solutions, what works with the current divided pinouts? I am in the process of a DIY 4x4 plasma table build and would like to utilize the CNC ports on the Powerplasmas...

What have others used?

[performance]

I don't keep up with those. Everlast doesn't test CNC systems as it isn't practical due to the many different companies out there making them and routine changes that they make...perhaps a few members who have them can chime in.

[everlastsupport]

search for arduino, I know Emptynester made his own and it might get others.

[Rambozo]

search for arduino, I know Emptynester made his own and it might get others.

You can find his project files HERE.