Share
Results 1 to 3 of 3

Thread: AC Power Requirements - 255EXT plus W300 water cooler

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. Default AC Power Requirements - 255EXT plus W300 water cooler

    I do not see mention of the AC circuit capacity required for the 255EXT or the W300 water cooler in the manuals. Can someone here give me a circuit size (Amps) to run this rig full-out? Are we talking 40 Amp with #8 wire (30 feet from panel), or will I need 50 Amp with #6 wire or larger? Thanks.

    David

  2. #2

    Default

    Mine says 34amp, so 40 is fine, but I would go 50 amps in case you want to get a plasma later and you are golden.
    Mike R.
    Email: admineverlast@everlastwelders.com
    www.everlastgenerators.com
    www.everlastwelders.com
    877-755-9353 x203
    M-F 12 - 7PM PST
    FYI: PP50, PP80, IMIG-200, IMIG-250P, 210EXT and 255EXT.

  3. #3

    Default

    It's in the manual, page 10. Water cooler manual info is on page 9.

Similar Threads

  1. 250 EX water cooler power output.
    By AWDnot2 in forum TIG Welding (GTAW/GTAW-P)
    Replies: 8
    Last Post: 07-28-2013, 06:56 PM
  2. W300 water cooler
    By bubbas55 in forum Multi-Process Units (TIG,Stick,Plasma/MIG,TIG,Stick Combo units)
    Replies: 4
    Last Post: 12-05-2012, 01:53 AM
  3. Water cooler requirements
    By dynasim in forum TIG Welding (GTAW/GTAW-P)
    Replies: 17
    Last Post: 05-21-2012, 04:46 PM
  4. Added a W300 Cooler
    By Gary in forum Multi-Process Units (TIG,Stick,Plasma/MIG,TIG,Stick Combo units)
    Replies: 0
    Last Post: 08-23-2010, 12:03 AM
  5. Question about W300 water cooler???
    By DisWeld in forum TIG Welding (GTAW/GTAW-P)
    Replies: 3
    Last Post: 08-03-2010, 11:28 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •