Board replacement instructions

[pavetim]

I have an I-mig 140E and getting sent a new board, anybody have instructions on how to do this?

[Rambozo]

I have an I-mig 140E and getting sent a new board, anybody have instructions on how to do this?

One tip, take good pictures of the board before you start unplugging things. That way you can refer back to make sure everything goes in the right place on the new board.

[pavetim]

What do I pull to change the board? I tried to pull off the front cover, removed the 2 top and 2 bottom Phillips screws and it won't come off. I didn't pull hard and stopped trying as I didn't want to mess it up. Once I figure out how to take it apart the board should be the easy part.

[performance]

As a general rule on all our units, never remove the front covers on an Everlast. That is the one of the first parts assembled!

Just remove the metal cover. The board is on the left side (facing unit) standing vertically from top to bottom. IIRC, there are about 6 screws holding the board in, and a ground wire at the top on the support rail. A few connections that are fairly simple to unplug and a power connection or two and it pops right out. Should take about 15 minutes to get it all out, if that much.