Power iMIG 275P Wire Feeder Alignment Question

[Baronsbest]

I have installed .035 flux cored wire on my new i275P unit. I ordered the knurled rollers from Everlast and have just swapped out the rollers, I did one at a time to make sure the fit up/alignment was the same between the new rollers and unit supplied rollers. Now that they are installed and I've run my wire through to the gun tube it appears that the wire isn't directly over the knurled wheel section, it's running what appears down the middle of the grooves on both rollers. First question, is the wire supposed to run on the inside groove like my millers? Second question, is there a way to adjust the alignment of the rollers easily so the wire is over the correct knurled grooves and has anyone run into this issue? Thanks in advance for your help.
Rj

[stretch]

Any pics baron....Would be a big help

[Baronsbest]

Sorry everybody, operator error. I didn't actually tighten down the idler roller and verify the wire was laying correctly, with my reading glasses on;-]. Once I did that the wire was in he groves correctly. Thanks Stretch for asking for the pic, it made me look closer at what was going on.
Rj