PowerPlasma 50 Problem

[octanechicken]

Hi, I purchased a PowerPlasma50 and have recently ran into a problem with it. After preforming a cut the airflow no longer shuts off. The post flow is set to 10 seconds and was functioning correctly up until yesterday. On occasion the air flow does stop. If the airflow is constantly blowing out I have to turn off the machine and then turn it back on before I can preform another cut. Is this a problem with the spring in the solenoid? Can I just re-tension the spring?

[performance]

Likely that is the culprit. But there are a couple of things that you can check first. Give Mike a call on Monday. I am sure he will help you trace for 100%.

[octanechicken]

I talked to Duncan about it and he's sending me a new solenoid on monday. Thanks