Power Plasma 50 Wiring

[cpierce18]

Just received my new Power Plasma 50. I just need to buy a plug for it now. Am I able to wire it up to 120vac, or does it NEED to be 220/240vac? I know i wont get the full power from 120, but it would work for now until i get the rest of the shop wired for 220. Can i do that?

[JonS]

Same question as CPierce...

The specs indicate that it will run 120/240. I have it setup right now for 240, but it would be nice to know for certain that it will run on 120 if I need to take it somewhere outside of my garage that doesn't have access to 240.

Does anyone know for certain if this unit will run 120V?

Thanks,

JonS

[Ray]

I've done it (some old posts somewhere. will not work above about 20-25, depending on the breaker.
It will work on thin stuff.

Ray

[JonS]

Ray,

I'm assuming when you say "above 20 - 25" you mean the setting of 20 to 25 on the machine and you're not referring to 20 to 25 amps at 110V.

Thank you for commenting.

Jon

[everlastsupport]

I would recommend waiting for the 220volts. Night and day difference and not all of our units will work on 110volts.

Does it have a 110/220volts AC sticker on the back of the unit.