250EX no amperage control

[TD2593]

It's been a long time since Ive been on the forum life just gets in the way. So here is my dilemma, My 250EX dated 10-15-2012 is giving my problems. I have not used the machine since May of this year and it worked great then. I keep it unplugged and covered when not in use. I plugged the machine up and am only getting a 007 on the display and no amperage control. The display stays on 007 no matter where the dial is. I do have HF and very low amperage in both AC and DC. What is my next thing to try ? I have had a L4-5 fusion so I have not been doing much at all in the shop as of late.

[TD2593]

http://weldingweb.com/showthread.php...do-not-display Just found this thread and tried everything this guy has tried and the display still reads 007 with finger control, Everlast pedal, my SSC pedal plug loose plug tight etc........

[Blaster]

Just to be clear, it does this with the pedal both plugged/unplugged in?

[christian]

Gee,

I'd just send it in to Everlast before the warrantee runs out, I mean, if they offered the 5-year coverage in 2012.

It'll cost around $100 or more in shipping, but that's not much for getting a five year old machine squared away.

[TD2593]

Yes with or without plugged in. I tried the original Everlast pedal as well and a finger tip control all the same.

Gee,

I'd just send it in to Everlast before the warrantee runs out, I mean, if they offered the 5-year coverage in 2012.

It'll cost around $100 or more in shipping, but that's not much for getting a five year old machine squared away.