Share
Results 1 to 2 of 2

Thread: 251si portable power source

  1. Default 251si portable power source

    hi there i am new to this forum and just finding my way still, i hope the was the appropriate board to post on.

    i have 251si and i am wondering if it would be safe to run it off my miller 302efi trailblazer?

    i cant seem to find the THD% in the manual or online.

    does anyone have any experiences running the 251si off a welder/generator such as a trailblazer or ranger.

  2. Default

    In Everlast's PDF manual it states:

    "Note: If a generator is going to be used with this unit, please make sure that it is cer ed by it’s manufactur- er to be “clean power,” which is normally stated as less than 5% THD ( Total Harmonic Distor on). For proper opera on with a generator, make sure you have at least a minimum 9,000 wa s of surge capabil- ity and 6500 wa s of con nuous rated output capabil- ity."

    I don't know what the Trailblazer is rated at for output, but I think it's lower in AC generator output than that, regardless of the THD. A Lincoln Ranger has more AC output, I believe, though.

    My 210EXT is reportedly rated well for use off a generator, with its PFC, but I've never used it with one.
    Everlast 210 EXT (2015)

    www.youtube.com/newjerusalemtimes

Similar Threads

  1. 251si voltage settings seem low
    By MichaelChad in forum Multi-Process Units (TIG,Stick,Plasma/MIG,TIG,Stick Combo units)
    Replies: 5
    Last Post: 03-06-2017, 01:43 AM
  2. New 251si
    By mattsbc in forum Introduce Yourself
    Replies: 8
    Last Post: 04-26-2016, 11:31 AM
  3. Tig cooler cooler power source - "warning"
    By Odyknuck in forum TIG Welding (GTAW/GTAW-P)
    Replies: 1
    Last Post: 12-17-2012, 09:37 PM
  4. 7 pin connector source
    By Tony_F in forum Multi-Process Units (TIG,Stick,Plasma/MIG,TIG,Stick Combo units)
    Replies: 13
    Last Post: 04-06-2011, 05:43 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •