Supercut 50P Overcurrent light

[cbmkr]

have not been on here for a while, Decided to use the 50P today to cut the end off a 48" round tank 3/8" material. stopped several times during the cut and the last time no spark trap was clean as i have a dryer. Let it set for at least an hour as i finished up with the torch still nothing any ideas or is it trash.

[performance]

Call our tech support at ext 207

[cbmkr]

Call our tech support at ext 207

Not sure if it is worth the trouble, $35.00 for shipping to your tech center, $35.00 Back to me , plus $150-300 for the repair I just don't think the machine is worth spending $150-300 on it plus shipping both ways.

[performance]

If it is out of warranty, it may not be worth it. It is our cheapest unit. But it is still considerably cheaper than the option of buying a new one.

[cbmkr]

Yes it is out of warranty, I am guessing less than 7or 8 hours of use. I am going to just buy a cheap throw away unit to have around when i need it. I was hoping it had some value but it looks like its just scrap.