requirements and part #'s for power arc 160

[yotarover]

i need the requirements or details on running the following using my power arc 160

carbon arc -previous thread was locked

tig- which torch to buy, foot control ? or finger tip? water or gas cooling ?

[performance]

The 160 will not support carbon arc.
The 17v torch is what you will need. There is no foot control with this type rig. It is a scratch/touch and weld. Its similar to any plain DC rig.

[yotarover]

alrghty thanx you really should tell your webmaster to take out the optional carbon arc for the 160 off the details page about it. also you only list 3 tig torches which one is it? as they have no other details about them other then the small discription

[performance]

My apologies, but it does say very clearly it is recommended only for the PowerArc 200. Please re read it. We use a similar template for both pages so people can see if they need to select another unit more appropriatley within another page, just as the page suggests: If you want to carbon arc, you will need to go to the 200.

The torch you need is a 17V torch. We do not carry them currently. You can find them on about any site that sells torches. It has a manual gas valve built in. It will need a DINSE 50 connection.