4t mode

[bobkat]

after installing my new regulator, i was doing some practice to get use to the machine, When i am using the torch in 4t mode pressing the button once to start the arc works fine , however hitting the torch button again at end of my weld, keeps on . Ithen can only break the arc by lifting the torch..Any suggestions
thanks

[performance]

You have to hold it until it finishes downslope, then release.

[bobkat]

you have to hold it until it finishes downslope, then release.

thanks mark, come to think of it i increased downslope right before i started having issues, sure glad they have you smart guys on here. My other color welders do not get as quick of a response.