Trouble shooting
Hello. I have a PowerPro 205. Had it in the shop for 5 months or so now. We ran a test when we first got it and it seemed to work then. I only made a few cuts in some 1/8 plate just to see that it was working.
I went to use it the other day after it sat covered up for a few months and noting would happen after pulling the trigger. The machine turns on fine, but pulling the trigger does not start the air or create an arc. I double checked that the air was on, and it was. Is there something I can check, or some way to trouble shoot where the problem lies? I am really left scratching my head at this point.
Thanks In advance
Reply With Quote