What all is involved in using an inverter to convert to DC tig?

[performance]

Scratch start TIG rig= wp 17V or wp17fv torch with either a lug like Shield Arc's or a DINSE 50 connector.

[I_Love_Plasma]

With the appropriate connectors would an aircooled torch from this place http://weldingdirect.com/tigtoairco.html work with a PowerArc 200?

[performance]

It shouldn't be a problem. We have the 17V's in stock which should be ideal for that unit.

[I_Love_Plasma]

Oh I didn't realize Everlast had them. Do you know a ballpark of what they retail for $?

[performance]

Not sure of hand, but its listed on the site under torches.

[ogorir]

hey mark, does that torch come with a dinse connector? that was the price killer on my scratch-start setup. the weldcraft WP9 torch was $63, but I think the dinse plug with the gas port was $33.

[performance]

Yes, its ready to go.
I THINK it even has an extra remote switch with the torch, though I am not positive on this one...though its not needed and is easily removed for the PA 200. Keep in mind this will be scratch start only, and low end amps are not what the 140 is.